Page 1 of 1

VRS and BT SmartHub 2

Posted: Fri Aug 20, 2021 5:04 pm
by Steve M
Has anyone had any problems when using BT SmartHub 2 and VRS? I am using VRS 2.4.4 from my SBS and I have set up Port Forwarding OK. My issue is that the VRS runs fine on the external address (via an address with NO-IP) for anywhere from about 24-36 hours and then suddenly it stops sending out externally. The internal address works fine all the time. I have shut down and restarted the VRS software but that doesn't solve the issue. I can only get the external address working again if I reboot the SmartHub. BT have changed the SmartHub and I still have the same problem. I also feed PlanePlotter and the Port Forward for that works fine all the time.

Does anyone have any suggestions that I could try?

Thanks