Page 1 of 1

changing the default address

Posted: Mon Jan 09, 2017 9:34 pm
by pilot4g
Is there any way to reconfigure the local address that is default to another in that IP range like ?
I am trying to use my adaware flight stick - dump1090win - virtual radar server - planeplotter - other clients (FR24 & others)
Using VRS & Planeplotter no issues, FR24 feed client has conflicts.
VRS working with rebroadcast server set for FR24 client by changing rebroadcast server - FR24 client works but the FR24 client config stops working as it
is hard coded to

Just wondering if the VRS local IP can be reconfigured or if anyone found another work around for a config like this

Re: changing the default address

Posted: Fri Jan 13, 2017 10:59 am
by Skibox
You are approaching this problem from the wrong angle. is NOT a normal IP address that you should configure, it just means "myself". It can't be changed. Where did you set ?

When a software is using it always points back to the device it is used on, regardless of what other IP addresses this device has.

So, revert all your changes back the original setting, and then find the REAL problem why some things are not working.

For example, in FR24feed, what type of receiver did you set? AVR-TCP ? RAW-TCP ? What port are you pointing it at ?

Most likely, you have a port conflict and/or a receiver type conflict.


Re: changing the default address

Posted: Sat Jan 14, 2017 4:09 pm
by agw
As skibox says, is the local loopback address, it just refers to the machine that the software is running on. 127.0.0.[1 to 255] are all local loopback addresses, and are the same. Think of it like a large office building that has the address 1-255 High Street. Letters addressed to 1 High Street and 5 High Street might look to the sender like they're going to different buildings but the postie is going to shove them both through the same letterbox.

So when you used you didn't really change anything, you just used by a different name. I'm guessing you're probably running into a port conflict and using looked like it fixed it because it defeated some port number validation in a configuration screen somewhere? It would defeat VRS's port validation, I don't treat all of the local loopback addresses as the same address. However, the underlying port conflict would still exist.

Re: changing the default address

Posted: Wed Mar 15, 2017 7:15 pm
by pilot4g
Thanks for the reply, I have been out of town for work and so just now getting to the hobby again
I am trying to use a flightaware stick (pc usb) connected with windump1090 - feed virtualradar server = All works fine
Now I want to add and also feed flightradar24 windows client to this setup now and there is a conflict.
The only way to get this working was to setup VRS with a "rebroadcast server" port 30002 and using configuration below.
What am I missing or get wrong? This is working, but is this the preferred setup

VRS is using

The FR24feeder client config is